Settings for the Entire TD (SYSTEM)
46
Viewing Information About
the TD (Information)
Here you can view information about the TD itself.
For details on the procedure, refer to “Basic procedure”
(p. 34).
Item Description
Program Ver. System program version
Restoring the Factory Settings
(Factory Reset)
This “factory reset” operation restores all drum kits and
system settings in the TD to their factory-set state.
NOTE
• All data and settings in the TD will be lost. If the TD
contains any data or settings that you want to keep,
you must save them to a USB ash drive before you
proceed (p. 38).
• This operation cannot be executed if “Write Protect”
(p. 35) is ON.
1. In step 4 of the basic procedure (p. 34), choose
“Factory Reset” and then press the [F3] (ENTER)
button to access the FACTORY RESET screen.
2. Use the value dial to select the type of data that
you want to reset.
Parameter Value Description
Target
ALL KITS All kits
SYSTEM System settings
ALL All data
3. Press the [F3] (RESET) button.
A conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
4. If you’re sure you want to execute the factory
reset, press the [F3] (OK) button.
Once again, a conrmation message will appear.
If you decide to cancel, press the [F1] (CANCEL) button.
5. If you’re sure you want to execute the factory
reset, press the [F3] (OK) button.
When the factory reset has been completed, the screen
will indicate “Completed.”
To Next Page
Loading...
Need help?
General