Rotex Solaris RPS3 25M User Manual

2 x Product description
10
FA ROTEX Solaris RPS3 25M - 03/2010
2.3.2 Flow rate meter and regulating valve
FlowSensor FLS100
FlowGuard FLG
2.3.3 Connecting pipes and extension kits
Connection set CON X20 25M
Connection set CON RA 25M
16 41 03
For measuring the flow rate (5 - 100 l/min) and the feed temper-
ature.
Consists of:
– Measuring section (a)
–Sensor (b)
– 3 m connecting cable (c).
– 2x seals (d).
Can be ordered as an option (see Chapter 5.2.6 "Solaris
FlowSensor"):
– FlowSensor FLS20 (1.5 - 20 l/min).
– FlowSensor FLS40 (2.5 - 40 l/min).
Illustration 2-3 FlowSensor FLS100 (optional)
16 41 02
For setting and displaying the flow rate from 2 - 16 l/min.
Consists of:
– FlowGuard FLG (a).
– 2x seals (b).
Illustration 2-4 FlowGuard FLG
16 42 32
For connecting a collector array (V21P, V26P, H26P) to the on-site
rigid copper connection pipes when using roof penetration kits
RCAP, RCRP, RCIP, RCFP.
Consists of:
– Push-in coupling fitting for return line with Ø 28 mm (a).
– Push-in coupling fitting for feed line with Ø 15 mm (b).
– 2 m feed line VA 15 Solar (c).
– 2 m return line VA 18 Solar (d).
Illustration 2-5 CON X20 25M (optional)
16 01 13
For connecting the return of a Sanicube Solaris or HybridCube hot
water storage tank to the on-site copper pump connection pipe.
Consists of:
– Connecting T-piece (a).
– Connection pipe with ball valve and connection fitting to
Ø 28 mm pipe diameter (b).
– Blanking plug with clamp (c).
Illustration 2-6 CON RA 25M (optional)

Rotex Solaris RPS3 25M Specifications

General

Brand	Rotex
Model	Solaris RPS3 25M
Category	Water System
Language	English