7
SPECIFICATIONS
UNPACKING
INSTRUCTIONS
Your Orbital Jig Saw has been shipped completely
assembled.
Carefully remove the tool and accessories from the
box.
Make sure that all items listed in the packing list are
included.
Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
APPLICATIONS
You may use the orbital jig saw for the purposes listed below:
Cutting wood surfaces.
Cutting thin sheet metal.
Cutting plastics and laminatess.
PACKING LIST
Orbital Jig Saw
Battery Pack
Blades (2)
Charger
Carrying Case
Operator’s Manual
WARNING:
If any parts are missing do not operate your tool until
the missing parts are replaced. Failure to do so could
result in possible serious personal injury.
WARNING:
The tool should never be connected to a power supply
when you are assembling parts, making adjustments,
cleaning, performing maintenance, or when the tool is
not in use. Disconnecting the tool will prevent acciden-
tal starting that could cause serious injury.
ORBITAL JIG SAW
Length of Stroke ......................................................................................................................................................... 1 in.
Strokes Per Minute.......................................................................................................................................... 2,100 SPM
Switch...................................................................................................................................................... Variable Speed
Blade Clamp...................................................................................................................................................... Tool-Less
Cutting Angle........................................................................................................................ 0º to 45º both Left and Right
Orbital Motion ....................................................................................................................................................................
CHARGER ASSEMBLY
Charger Input ........................................................................................................................... 120 Volts, 60 Hz, AC only
Charger Voltage ..................................................................................................................................................... 18 Volt
Charge Rate ........................................................................................................................................................... 1 Hour
To Next Page
Loading...
Need help?
General
