Sagi KD6Q User Manual

GB
22
USEFULL ADVICES FOR THE CARE OF THE STAINLESS STEEL
For the cleaning and mantainance of the parts of stainless steel follow the advices written below, bearing in
mind that the first and fundamental rule is to guarantee the non toxicity and best hygiene of the dealed
products.
The stainless steel has a thin oxide coat that prevents rust formation.
But there are substances or detergents that can destroy this coat and give origin to corrosions.
Before using any detergent product ask always your dealer about which neutral detergent is the most
qualified and does not cause corrosions on the steel.
In case of scratches on the surfaces it is necessary to smooth them using thin STAINLESS STEEL wool or
an abrasive sponge in synthetic fibrous material, wiping in the direction of the satin
WARNING: for the cleaning of the STAINLESS STEEL never use iron wool and never let them rest on the
surfaces because little iron deposits could remain on the surfaces and cause rust formations by
contamination and endanger the hygiene.
USAGE INTERRUPTIONS
In case of longer inactivity of the refrigerator and for maintaining it in the best state act as following:
- set the general cut-out in OFF position.
- remove the plug from the socket.
- empty the refrigerator and clean it as described In the chapter "CLEANING".
- let the door open to avold the forming of bad smell.
MALFUNCTIONING
Malfunctioning during operation is often due to banal causes , whitch may nearly all be resolved without the
help of a specialised technician. Consequently, before getting in touch with a service centre, check the
following:
PROBLEM
POSSIBLE CAUSES
The appliance does not start
Check that the plug is properly inserted into the socket.
Check that there is voltage at the socket
The internal temperature is too high
Check the electronic card adjustment
Check for a heat source in the vicinity
Check that the door closes properly
The appliance is excessively noisy
Check that the appliance is standing level. A lopsided
appliance could set off vibrations
Check that the appliance is not touching other appliances
or parts which could resonate
Some condensation is produced on the
appliance
Room humidity is very high
The door is not closed properly
Upon completion of the above checks, if the fault persists, contact an authorised service centre. Always
indicate:
• the nature of the fault
• the model and the serial number of the unit can be found on the electrical specifications plaque, located
on the unit’s instrument panel.

Sagi KD6Q Specifications

General

Brand	Sagi
Model	KD6Q
Category	Freezer
Language	English