User Manual
35
User Manual
36
RS485-M cable
RS485-M cable is used to connect Inverter and RS485/232 Module. Users only
use 2 wires of the 5E cable to connect to the Connector and the RS485/232
Module according to Table 2. Make sure they are fixed well.
Table 2 RS485-M Cable Assembly Order
RS485-L cable
RS485-L cable is used to connect Inverter and SAJ Logger when inverters are
monitored via RS485. One end of the cable uses 3Pin Connectors, and the
other end uses RJ45 Plug. Connection is shown in Table 3 as below:
Table 3 RS485-L Cable Assembly Order
Figure 6.25 RJ45 Plug and Its Pin Number
Tools
When making a communication cable , the professional tools shown in
Figure6.26 below are needed.
Figure 6.26 Tools for making a communicate cable
RS485 cable
When Inverters use RS485 for monitoring, users need RS485 cables to connect
between Inverters for multipoint monitor. In this case, we provide Connection
by using the 3Pin Connector as shown in Figure6.24.
Each end of the cable should be connected to the Connector according to Table
1. Make sure they are fixed well.
Table 1 RS485 Cable Assembly Order
Connector No.
Wire
1
2
3
Blue & White
Blue
Metal shielded wire
Wire
Blue & White
Blue
Connector No.
1
2
RS485 / 232 Module
D-/B
D+/A
Wire
Blue & White
Blue
Connector No.
1
2
RJ45 plug's Pin NO
5
4
To Next Page
Loading...
Need help?
General
