User Manual
46
User Manual
8. RECYCLING AND DISPOSAL
To comply with European Directive 2002/96/EC on waste Electrical and
Electronic Equipment and its implementation as national law, electrical
equipment that has reached the end of its life must be collected separately and
returned to an approved recycling facility. Any device that you no longer
required must be returned to your dealer or you must find an approved
collection and recycling facility in your area.
Ignoring this EU Directive may have severe affects on the environment and
your health.
WARNING
This device shall not be disposed of in residential
waste.
7.2.10 Inverter-Info
User can read the inverter detailed machine information:
User can enter the corresponding sub-menu to see the detailed information .
Enter the “Firmware Ver” , it will show the firmware version of master control
unit, slave control unit, display board (the firmware version will vary when it is
updated)
SN code
Product Code
>
> Machine Type
Grid Compliance
Firmware Ver>
45
9. TROUBLESHOOTING
Clear Energy:
Be caution that this operation will clear up the generated energy data of E-
Today、E-Month、E-Year、E-total、T-Today、T-Total etc.
If user wants to clear up the generated energy record, move the cursor to "clear
energy" and press “ENT”to enter the sub-items, press “ENT” to confirm the
setting when the below menu occurs. Press ESC or ENT to exit when "Set
complete!" appears.
Factory Setting(Only for SAJ or SAJ representative):
Note: This operation will erase all history data record, such as generated energy,
error logs etc. And the password and Grid Compliance will be set back to default
settings.
Enter “Factory Setting” menu to enter the password, the system will required
users to re-confirm “Factory Setting”. Press “ENT” button to confirm. You can
see “Set complete” to finished the “ Factory setting” and press “ESC” or “ENT”
to exit the “ Set complete”
To Next Page
Loading...
Need help?
General
