Samson Meteor Mic Owner's Manual

6
Installing the Meteor Mic
Installing the Meteor Mic is a simple procedure that takes just a few minutes. Simply connect the
included USB cable and begin recording. The following sections of this manual provide detailed
instructions on setting up your Meteor Mic in MAC OS or Windows.
Windows 7 & Windows Vista
1. The rst time you plug the Meteor Mic into a USB port, Windows 7 or Vista will install the
universal drivers for that port. A balloon will pop up, telling you the computer has found the
Meteor Mic.
2. When it is nished installing the drivers, a balloon pop up will say “Your device is installed and
ready to use.”
Note: This balloon will only pop up when you rst plug the device into a particular USB port.
3. To set the Meteor Mic as your default device for sound playback and recording, or to change
its settings, click the Start button, click Control Panel and then click Sound. Under the Playback
and Recording tabs, you can select the Samson Meteor Mic from the menus and use the Set
Default button to set it as the default device.
4. To set the gain of the microphone, click the Properties button, and then select the Levels tab.
You can choose to view the Microphone volume level as either a percentage or in dB, by right

Samson Meteor Mic Specifications

General

Type	Laptop microphone
Bit rate	16 bit
Sample rate	48 kHz
Noise reduction	Yes
Microphone frequency	20 - 0.02 Hz
Microphone direction type	Cardioid
Device interface	USB
Connectivity technology	Wired
Number of products included	1 pc(s)
Product color	Chrome