4
Assemble Your Device
Assemble Your Device
This section helps you to
assemble your device.
Install the SIM Card
When you subscribe to a cellular network, you are
provided with a plug-in SIM card. During activation,
your SIM card is loaded with your subscription
details, such as your PIN, available optional
services, and other features.
Warning: Please be careful when handling the SIM
card to avoid damaging it. Keep all SIM cards out of
reach of small children.
1. Carefully pull the SIM card tray out of the slot.
2. Place the SIM card on the tray, and slide the tray
back into the slot.
Make sure that the card’s gold contacts face
down into the device and that the card is
positioned as shown.
Important: To prevent water and dust from entering
the device, remove any dust on the O-Ring and ensure
the SIM card tray is closed tightly.
Caution: If the card is not inserted correctly, the
device cannot detect the SIM card. Re-orient the
card and place it back into the slot if the SIM is
notdetected.
Maintaining Water and
DustResistance
Note: Water-resistant and dustproof based on
IP68rating, which tests submersion up to
1.5 meters for up to 30 minutes.
This device is rated IP68 using the Ingress
Protection rating system.
Your device has been tested in a controlled
environment and shown to be water and dust
resistant in certain circumstances (meets
requirements of classification IP68 as described by
the international standard IEC 60529 - Degrees of
Protection provided by Enclosures [IP Code]; test
conditions: 15-35°C, 86-106 kPa, 1.5 meter, for
30minutes). Despite this classification, your device
is not impervious to water damage in any situation. It
is important that all compartments are closed tightly.
Follow these tips carefully to prevent damage to the
device.
•
Whenever your device gets wet, dry it thoroughly
with a clean, soft cloth.
•
Do not expose the device to salt water or ionized
water, or to water over 1.5 meter deep for more
than 30 minutes. If your device is exposed to
fresh water, dry it thoroughly with a clean, soft
cloth. If the device is exposed to any liquid other
than fresh water, rinse the device with fresh water
immediately and dry it thoroughly with a clean,
soft cloth. Failure to rinse the device in fresh water
and dry it as instructed may cause the device to
suffer from operability or cosmetic issues.
•
Do not expose the device to water at high
pressure, such as ocean waves or a waterfall.
•
If the device is dropped or receives an impact,
the water and dust resistant features of the device
may be damaged.
•
The touchscreen and other features may not work
properly if the device is used in water or in other
liquids.
To Next Page
Loading...
Need help?
General
