10 English
Before you start
Before you startInstallation
After installation is complete, remove the protective lm, tape, and other packing
material, and take out the provided accessories from inside the oven. To remove
the oven from the cabinet, rst disconnect power to the oven and remove
2 screws on both sides of the oven.
WARNING
The oven requires ventilation for normal operation. Do not block the vents under
any circumstance.
NOTE
The actual appearance of the oven may differ with the model.
Before you start
Initial settings
When you power on the oven for the rst time, the default time of “12:00” appears
on the display where the hour element (“12”) blinks. Follow the steps below to set
the current time.
1. With the hour element blinking, turn
the value dial (right-sided dial) to set
the hour, and then press OK to move to
the minute element.
2. With the minute element blinking, turn
the value dial to set the minute, and
then press OK.
To change the current time after this
initial setting, hold down the button for
3 seconds and follow the above steps.
NV75N7647RS_SA_DG68-01056N-00_EN.indd 10 2020-04-17 오후 3:40:09
To Next Page
Loading...
Need help?
General