Remote Control Transmitter
5
1. Open the battery cover.
2. Install two “AA” 1.5 volt batteries so that the “+” and “-” marks on the batteries match the “+” and
“ - ” marks inside the unit.
3. Close the battery cover.
Note: Replace the batteries when the TV set is showing the following symptoms:
Operation is unsteady or erratic, sometimes the TV set does not work with transmitter.
Discharged batteries may leak and damage the unit. The normal life of batteries should be from
nine to ten months.
S. SYS
Power ON/OFF button
ALTERNATE button
VOLUME + button
TIMER button
MUTE button
CHANNEL SCAN button
SURROUND button
PICTURE MODE button
Programme UP button
RECALL/COLOUR SYSTEM button
MENU button
TV / AV Selector button
Programme Selector button
SWAP button
VOLUME - button
STEREO/MONO button
Programme DOWN button
BASS EXPANDER button
SOUND MODE button
(This button is not used)
SOUND SYSTEM button
DIGIT button
Battery Installation of the Remote Control Transmitter
General Operation
Important !
Be sure to set the Mains ON/OFF switch to the off
position, if the power failure occurs while viewing.
To switch on or off the TV ;
Press the Mains ON/OFF button.
The power of the TV is turned on or off complete-
ly. If no picture appears but the Standby and
Power indicator illuminates, press the POWER
ON/OFF button of the remote control transmitter
as the TV set is in standby mode.
To set the TV to standby mode;
Press the POWER ON/OFF button.
During Standby mode the Standby and
Power indicator illuminates more brightly.
To turn on the TV from the standby mode, press
any of the following button.
● POWER ON/OFF button of the remote control
transmitter.
● Programme UP/DOWN of the remote control
transmitter or the TV set.
● 1 to 9, 0 button on the remote control
transmitter.
Power ON/OFF
To Next Page
Loading...
Need help?
General
