■ NO PICTURE, NO SOUND
● Check if TV is plugged in.
● Try a different channel, if OK, probably station trouble.
■ POOR PICTURE, SOUND OK
● Adjust BRIGHTNESS control.
● Adjust FINE TUNING control.
● Check aerial connections
■ NO COLOUR, PICTURE OK
● Adjust COLOUR control.
● Adjust FINE TUNING control.
● Is the programme in colour ?
■ WEAK PICTURE
● Check aerial connections on back of set.
● Check aerial for broken wires.
● Re-orient aerial.
■ The following faults are not caused by the
receiver:
"GHOSTS"
Reflections of signals from mountains or high build-
ings will cause multiple images, called "Ghosts".
These abnormal conditions can be reduced to mini-
mum by repositioning aerial or by installing a new one
suited for your area.
"INTERFERENCE"
Interference may be caused by electrical appliances,
car ignition systems, etc. This should normally be a
temporary condition, but should this interference per-
sist, contact your dealer.
Power Source AC220-240 Volts, 50/60Hz
Colour System PAL/NTSC4.43/NTSC/PAL-60Hz
Sound System B/G, I, D/KK’, M/M
Channel Coverage
VHF: E2-E12, A2-A13, R1-R12, J1-J12, K1-K9
0-11, 5A (AUS), 1-11 (NZ)
UHF: 21-69, A14-A69, J13-J62,
28-69 (AUS)
CATV: S1
-
S41, X, Y, Z, Z+1, Z+2
Aerial input impedance 75 Ω
Audio output (RMS) : 5 W + 5 W (All Models)
Speakers : 5 x 9 cm x 2 pcs (All Models)
Ext. terminals
DVD Video Component: Composite/Component Y,
CB,CR input (Optional Models)
Video inputs: Phone Jack x 2 (1.0Vp-p, impedance 75Ω)
Audio inputs: Phone Jack x 2 (436mVrms, impedance
more than 40KΩ)
Video monitor outputs: Phone Jack x 1 (1.0Vp-p,
impedance 75 Ω)
Audio monitor outputs: Phone Jack x 1 (436mVrms,
impedance less than 600Ω)
Dimension
Model CP14SE1, CA14SE1:
433 (W) x 336 (H) x 353 (D)mm
Model CP21SE1, CA21SE1:
580 (W) x 460 (H) x 457 (D)mm
Weight
Model CP14SE1, CA14SE1: approx. 8.7 Kg
Model CP21SE1, CA21SE1: approx. 18.7 Kg
Specifications subject to change without notice.
Specifications
Helpful Hints
Care and Cleaning / Specifications / Helpful Hints
Care and Cleaning
The surface of the cabinet can be damaged if not properly maintained. Many common household aerosol sprays, clean-
ing agents, solvents and polishes will cause permanent damage to the fine surface.
1. Unplug the power cord before cleaning the Television.
2. Clean the screen with a soft cloth dampened with glass cleaner or warm water.
3. Clean the cabinet with a soft cloth dampened with a mild household detergent and warm water. Dry
thoroughly.
Note: NEVER spray liquids on the screen because they can run down and drip onto the chassis. This may cause com-
ponent failure not covered under Warranty.
10
To Next Page
Loading...
Need help?
General
