Sanyo CP14SE1 User Manual

5
Timer
ON-TIMER
When the ON TIMER is set. TV will automatically be switched on to the selected programme position when the specified
time has elapsed.
1
Press the TIMER button twice. Press the VOLUME ( + or - ) button. The set time will be increased or decreased
by 10 minutes each time the button is pressed ; the maximum time which can be set is 24 hours.
■ If no operation is performed after the TV has been switched on by the ON TIMER, such as if you are not at home,
the TV will be automatically switched off after approximately 2 hours.
■ If the TV is already switched on when the time set for the ON TIMER has been reached, only the programme position
will be changed to the set programme position.
■ Cancelling ON TIMER. To cancel the ON TIMER, press the VOLUME ( + or - ) button to set it to “ON 0:00” while the
ON TIMER screen is shown. Switching off the TV by pressing the Mains ON/OFF button will also cancel the ON
TIMER settings.
2
Use Direct programme Selection to insert programme position for when TV is switched on by ON TIMER.
T
T
imer / Pictur
imer / Pictur
e Adjustment
e Adjustment
Picture Adjustments
Picture Menu Operation
1
Press the MENU button for MAIN menu
display.
Approximately five seconds after you release the VOLUME
(+ / - ) button, the screen display switches from the adjust-
ment screen to the normal TV screen.
2
When “PICTURE” is not selected, select “PICTURE”
with the Programme UP or DOWN button.
4
Select desired control by pressing the Programme
UP or DOWN button.
3
Press the VOLUME + or - button to display Picture
Adjustment menu.
5
Press the VOLUME + or - button to alter
settings.
■ To return to Main menu, press the
ALTERNATE button.
■ To return to the normal TV mode, press the
MENU button. ( Or will automatically return to
the normal TV mode after 20 seconds.)
(MAIN MENU)
LANGUAGE
PRESET
SELECT ENTER
PICTURE
BACK
P
P
M
EXIT
WHITE TONE : Adjusts white balance.
FINE TUNING : Fine tuning in case of weak broadcast
signal or poor reception. Only displayed in TV mode. Will
not be displayed in AV mode.
The 2nd page is not displayed when there is no TINT
adjustment.
BRIGHT
TINT
CONTRAST
SHARPNESS
SELECT ADJUST BACK
P
P
M
EXIT
COLOUR
Page 1
Page 2
FINE TUNING
SELECT ADJUST BACK
P
P
M
EXIT
WHITE TONE
Picture Adjustment Item
COLOUR : Adjusts colour intensity.
BRIGHT : Adjusts picture brightness.
CONTRAST : Adjusts picture contrast.
TINT : Adjust colour tints. (Displayed only on
NTSC or NTSC4.43 system signal reception.)
SHARPNESS : Adjusts picture detail.
LANGUAGE
PRESET
SELECT ENTER
M
EXIT
PICTURE
AUDIO
(Monaural Model
MAIN MENU)
INST.BB2V 8/19/06 4:02 PM Page 5

Sanyo CP14SE1 Specifications

General

Brand	Sanyo
Model	CP14SE1
Category	TV
Language	English