Screensaver
Start
Mode
Off
PRESENT TIME MON 0 : 02
1/2
Signal
Input label
Wobbling
Setup
Power management
Off
Off
Auto power off
Off
Standby save
Off
(
SERIAL
)
ECO
Off
OSD Language English(UK)
Component/RGB-in select
RGB
Screensaver
29
Screensaver (For preventing image retention)
Do not display a still picture, especially in 4:3 mode, for any length of time.
If the display must remain on, a Screensaver should be used.
When the screen saver is operating, the following 5 patterns are displayed full screen for 5 seconds each.
Black→Dark Gray→Gray→Light Gray→White
2
1
3
Press to display the Setup menu.
Press to select Screensaver.
Press to display Screensaver screen.
Mode selection
Start setting
4
When the Mode is set to On, press to select Start.
Press to start Screensaver.
The menu screen will disappear and the Screensaver will be activated. To stop the
Screensaver under On, press the R button or any buttons on the main unit.
Note: When the display is turned off, the Scrensaver will be deactivated.
Press to select Mode.
Press to select each
mode items.
Off
Interval
: Operates when Periodic Time and Operating
Time are setup and those times arrive.
Time Designation
: Operates when Start Time and Finish Time
are setup and those times arrive.
Standby after SCR Saver
: Operates while Screensaver duration, and
display enters standby mode.
On
: Operates when Start is selected and the
ACTION ( ) button is pressed.
To Next Page
Loading...
Need help?
General
