Sanyo PID-42NE1 User Manual

31
Reduces power consumption
1/2
Signal
Input label
Wobbling
Setup
Off
Power management
Auto power off
Off
Standby save
Off
(
SERIAL
)
ECO
Off
OSD Language English
(
UK
)
Component/RGB-in select
RGB
Off
Screensaver
Press to select the menu to adjust.
Press to select “On” or “Off”.
On Off
Press to exit from Setup.
1
2
3
• Power management: When this function is set to On, it operates under the following conditions to turn the
power on or off automatically.
When no pictures are detected for 30 or so seconds during input from PC IN or
DVI-D IN terminal:
→ Power is turned off (standby); the power indicator lights up orange.
When pictures are subsequently detected:
→ Power is turned on; the power indicator lights up green.
Notes:
• This function operates only during input from PC IN or DVI-D IN terminal.
• This function is effective when “Sync” is set to “Auto” and during normal viewing (one
picture screen).
• Auto power off: Equipment power supply is turned Off when there is no signal.
When this is set to On, the power supply of the unit goes Off 10 minutes after the
input signals stop.
Note:
This function is effective during normal viewing (one picture screen).
• Standby save: When this function is set to “On”, serial communication is disabled during standby
mode, reducing the power consumption during standby.
To perform serial communication while in standby, set this function to “Off(SERIAL)”.
However, the standby power consumption is greater than when it is set to “On”.
• ECO: This function adjusts the brightness of the backlight to reduce power consumption.
Off: This function does not operate.
On: Backlight brightness is reduced.
Sensor: The backlight brightness is automatically adjusted according to the viewing
environment.
Note:
When this function is set to “On” or “Sensor”, the “Backlight” setting in the Picture
menu is disabled.

Sanyo PID-42NE1 Specifications

General

Brand	Sanyo
Model	PID-42NE1
Category	Monitor
Language	English