Computer Input
Basic Operation
25
Choose either Computer 1 or Computer 2 by pressing
the INPUT button on the top control or press the
COMPUTER button on the remote control. Before
using these buttons, correct input source should be
selected through Menu operation as described below.
Input Source Selection
Direct Operation
Computer 1
COMPUTER button
INPUT button
✳ See Note at the bottom of this page.
✳
Remote Control
Top Control
INPUT button
COMPUTER button
Computer 2
Video
Computer 1
✳
Computer 2
Input Menu
Input Menu
Move the pointer (red
arrow) to Computer 1 and
press the SELECT button.
Input Menu icon
Move the pointer (red
arrow) to Computer 2 and
press the SELECT button.
Move the pointer to RGB
and press the SELECT
button.
Source Select Menu
Computer
1
Press the MENU button to display the On-Screen
Menu. Press the Point 7 8 buttons to move the
red framed pointer to the Input Menu icon.
1
Press the Point ed buttons to move the red
arrow pointer to either Computer 1 or Computer
2, and then press the SELECT button.
2
After the Source Select Menu appeared for
Computer 1, move the pointer to RGB and then
press the SELECT button.
3
Menu Operation
✔ Note:
• When the Input Search function is set On1
or On2, the input signal will be searched
automatically (p.46)
• C o m p u t e r 2 i s n o t d i s p l a y e d w h e n t h e
COMPUTER IN 2/MONITOR OUT terminal is set
as Monitor out. (p.47)
• Computer 2 (COMPUTER IN 2/MONITOR OUT)
can accept only RGB signal.
To Next Page
Loading...
Need help?
General
