Setting
Setting
Display
Press the Point 7 8 buttons to switch On/Off. This
function decides to display On-Screen Displays.
On. . . . . . . . . . . . . Show all the On-Screen Displays.
Use this function when you want
to project images after the lamp
becomes bright enough. Factory
default setting is this mode.
Countdown off . . . Show the input image instead of
the countdown when turning on
the projector. Use this function
when you want to project the
image as early as possible even
w h e n t h e l a m p i s n o t b r i g h t
enough.
Off. . . . . . . . . . . . . Do not show On-Screen Displays,
except;
● On-Screen Menu
● "Power off?" message
● P-Timer
● "No signal" message for Power management item
(p.47)
● "Please wait..." message
● Arrows for True item in the Screen Menu (p.32)
Logo select
This function decides the start-up display as follows:
User
. . . . the image you captured
Default
. . the factory-set logo
Off
. . . . . countdown only
Logo (Logo and Logo PIN code lock settings)
This function allows you to customize the screen logo
with Logo select, Capture, and Logo PIN code lock
functions.
✔ Note:
When On is selected in Logo PIN code lock
function, Logo select and Capture functions
cannot be selected.
Logo select
To Next Page
Loading...
Need help?
General
