Sanyo VM-EX25P User Manual

INSTALLING THE
LITHIUM BATTERY
After the lithium battery is installed, the time and date will
The linear time counter indicates the tape run time in need to be set. (See page 15.)
hours, minutes and seconds. 1 Open the lithium battery tray (at the bottom of the
@ Press the COUNTER RESET button to reset the counter camcorder), using a coin as shown below.
to
“0:00:00”.
If
you
reset
the
counter
at
the
beginning
of
2
Insert
the
lithium
battery
in
the
tray
with
the
(+)
sign
the tape, you can determine the recording duration. facing up.
e Press the COUNTER MEMO button and “M” is 3 Insert the tray back into the camcorder.
displayed. When “M” is displayed, the “0:00:00” point is
memorized (not the point where the COUNTER MEMO
button was pressed). Press the COUNTER MEMO
button again to erase the “M” and cancel the memory
function.
Using the memory function
1 Press the COUNTER RESET button.
2 Press the COUNTER MEMO button.
3 Set the POWER switch to “PLAYER”.
4
Press the REW button. The tape will be rewound and
will automatically stop at the counter reading “0:00:00”.
iss Notes:
@ Before use, wipe the battery clean with a dry soft
cloth to assure good contact.
@ Never use metallic tweezers to hold the battery, and
never short circuit the (+) and (—) sides of the battery.
@ Under normal conditions, the lithium battery should
last about 1 year. If the lithium battery is expired
'88:88' will flash in the viewfinder.
WARNING:
@ The lithium battery must only be replaced with a lithium
battery model number Sanyo CR2025 (3 V].
ua
Notes:
Use
of
another
lithium
battery
may
present
the
risk
of
@
When
pressing
the
REW
button,
the
tape
might
not
fire
or
explosion.
stop
at
the
exact
“0:00:00”
location.
@
Keep
the
batteries
away
from
children.
@
if
tape
is
rewound
past
“0:00:00”,
the
counter
ef
a
battery
is
swallowed,
see
a
doctor
immediately.
reading
will
indicate
a
negative
'—'
value.
e
Dispose
of
used
lithium
batteries
promptly,
in
a
safe
manner
that
complies
with
all
applicable
laws.
@ The lithium battery may present the risk of fire or
chemical burn if mishandled. Do not recharge,
disassemble, heat above 212°F (100°C) or dispose of in
the fire.
14

Sanyo VM-EX25P Specifications

General

Brand	Sanyo
Model	VM-EX25P
Category	Camcorder
Language	English