Sanyo VM-EX25P User Manual

SETTING THE DATE AND TIME
Example: Setting the date and time to 2:10 P.M.,
December 24, 1994.
When holding the DATE button to set the date and time,
the numbers will change rapidiv. When the desired setting
approaches, release the button, then press it repeatedly
so that the desired number is not missed.
Use a thin object, such as a pen, to press the ADJ button
on the bottom of the camcorder.
1 Setthe POWER switch to 'CAMERA'.
2 Press the ADJ button for about two seconds. The reset
time (0:00:00) and date (1. 1. 1993) are displayed
flashing.
3 Press the DATE button until the desired day (24) is set,
then press the ADJ button.
4 Press the DATE button until the desired month (12) is
set, then press the ADJ button.
5 Press the DATE button until the desired year (1994) is
set, then press the ADJ button.
6 Press the DATE button until the desired hour (14 (2
P.M.)) is set, then press the ADJ button.
7 Press the DATE button until the desired minutes (10)
are set.
The seconds counter will start counting from “00”
when the ADJ button is pressed after setting the
minutes. To set the seconds accurately, press the ADJ
button in coordination with the actual time indication
(radio signal, etc.).
t Notes:
@ The date and time are not displayed when the
POWER switch is set to “PLAYER”.
@ The date and time cannot be set while in recording
or playback mode.
elf “88:88” is displayed flashing, it indicates that the
lithium battery is exhausted. Replace it with a new
one, and reset the date and time.
@ The date and time need to be set only once.
However, they will need to be reset after the lithium
battery is replaced.
15

Sanyo VM-EX25P Specifications

General

Brand	Sanyo
Model	VM-EX25P
Category	Camcorder
Language	English