Sanyo VM-RZ2R User Manual

RECORDING BASIC STEPS
#1. Install a charged battery pack on the camcorder. i
F n {See pages 7 and 8.) onenean
:2 Load a cassette tape. (See page 7.) M
13 Set the POWER switch to “CAMERA”. i
¢ Set the POWER switch while holding down the small ;
2
H
:
$
button in the centre of the switch. i
‘Å Set the AUTO LOCK switch to “AUTO LOCK”. (See |
‘Page 11.) ,
PASADA LAMADA NININA n aLe P eN ON APIO AA pS a RATON A ONL O eOe ST oo eS aS aS
PAMIATKA LaO LaCa asa Laa A eee CACAO HARA
5 Set the stand-by switch to “READY”.
“PAUSE” is displayed in the viewfinder.
When the POWER switch is set to “CAMERA”, the
stand-by switch is used as follows: i
(A) “READY” position
For recording; press the REC START/STOP
CEEE Oat San an a Sn EEEE
: button to start recording or to go into recording
i pause mode. A
: (B) “HOLD” position :
When not recording momentarily; the power to
the viewfinder is cut in order to save the battery
pack charge.
EAEL LAP PLDI SA PAREREA AIARA PRAA aranana nananana
‘6 Press the REC START/STOP button to start _
recording.
aces VAAN KASAEANE AALT ACR AAAS ACOCRCALACP AO VVAA AAPA AAA OCA OLN EM
To stop recording, press the REC START/STOP button
again. Recording will stop and “PAUSE” will be displayed
in the viewfinder. To resume recording press the REC
START/STOP button again.
When finished recording, press the REC START/STOP
button, then unload the cassette tape and set the POWER
switch to “OFF”.
t% Notes:
@ Vertical stripes may appear when recording in a
dark place a light source such as a candle light, etc.
@ |f a recording pause continues for more than 5
minutes, the power is cut to prevent the tape from
being damaged. To resume recording, press the
REC START/STOP button twice.
@ When the lighting conditions change, or when filming
a plain white subject, the colours might turn reddish
or bluish. To reset the colours to normal, film a well lit
and contrasted subject.
Eyesight compensation ring
Turn the camcorder on, then while looking into the
viewfinder turn the ring (C), to the right or to the left, to
obtain the clearest possible picture.
POWER
CAMERA OFF PLAYER
Recording review
If the camcorder is in recording pause mode, press and
release the SCENE SEARCH (-) button once to review, in
the viewfinder, the last few seconds of the recording.
Then, the camcorder will automatically return to recording
pause mode at the exact point where it previously was.
t Note: Do not hold the SCENE SEARCH (-) button as
the camcorder will go into scene search mode.
ENGLISH

Sanyo VM-RZ2R Specifications

General

Brand	Sanyo
Model	VM-RZ2R
Category	Camcorder
Language	English