satoh Buck S-470 User Manual

FRONT AXLE CENTER PIN AND FRONT HUB
A heavy load is always applied. to the front axle center pin; therefore
sufficient grease is always required at this point. Check the pin for
deterioration at frequent intervals.
The freon't hub has been lubricated with grease and carefully assembled in
the factory. However, further checking every 50 hours is required.
When grease is' insufficient or pre-load is incorrect supply more grease or
adjust the. pre-load.
Front wheel hub frictional torque: 0.04 ~ 0.06 kg-m (0.29 ~ 0.43 ft-Ib)
BATTERY
NOTE: __________________________________________ __
The electrical system on S-470 and S-470D is of negative earth type. Care
should be taken to ensure that the battery terminals are correctly
connected when installing the battery.
The battery equ ipped is PO L YM I ON battery model G 1 00-S6.
Though small-sized, it shows 40% high performance as compared with
the conventional batteries of the same size.
Offering some 100AH of engine starting energy, the Gl00-S6 battery
powers the engine effectively specially in cold weather.
Daily checking and servicing are the same as for previous batteries.
1. The specific gravity of the electrolyte is 1.280 ± 0.010 at 20° C
(68°F).
- 50-

satoh Buck S-470 Specifications

General

Brand	satoh
Model	Buck S-470
Category	Tractor
Language	English