satoh Buck S-470 User Manual

TREATMENT OF A NEW TRACTOR
All components of SATOH tractors model S-470 & S-470D are subject to
stringent checking during assembly in the factory. However, a new
tractor should be carefully checked over by the operator himself. For the
first 25 ~ 50 hours operation, heavy duty work should be avoided. If
heavy duty work is unavoidable, drive in a gear one stage lower than you
would normally use, and run the engine at lower speed.
50-HOUR SERVICE
When the tractor is brand new, after the first 50 hours running, the
following service, maintenance and checking should be carried out.
(1) Replace the engine oil filter and engine oil.
(2)
Replace the transmission oil and clean the hydraul ic oil filter.
(3) Retighten all bolts and nuts.
(4) Check and adjust the fan belt tension.
(5) Check the wheels to see if their condition is good and tire pressure is
correct.
(6) Retighten the cylinder head bolts and adjust valve clearances.
(7) Front axle diff. case and gear case oil replacement of 4-wheel drive
tractor.
(8) Cooling water replacement.
(9) Air cleaner element cleaning.
(10) Clean the fuel filter.
(11) Check the front hub for end-play.
(12) Check the battery electrolyte.
This 50-hour Service is an essential procedure for keeping the tractor in
top condition, so it must be done properly.
-1-

satoh Buck S-470 Specifications

General

Brand	satoh
Model	Buck S-470
Category	Tractor
Language	English