www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
22
|
GB
ing woodworking machines must also be observed.
occur due to a failure to observe this manual and the
2. Device description
1. Guard
2.
3.
4. Handle
5. Trunk guide plate
6. Triggering button
7. Ventilation screw
8. Oil drain screw with dipstick
9. Support surface
10. Pressure plate
11. Control lever protection
12. Control lever
13. Motor
14. Transport wheels
15. Pressure limiting screw
16. Foot
3. Scope of delivery
A. Operating manual
B.
C. Handle
D. Log splitter
E. Top guard 1
F. Top guard 2
G. Left guard
H.
I.
J. Front guard
K.
L. Protective guard
M.
N.
O. Strut
1. Introduction
Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Dear customer,
and success.
Note:
the product that occurs due to:
• Improper handling,
•
•
technicians,
•
parts,
•
•
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
We recommend:
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord
ance with the recommendations.
The operating instructions contain important infor
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
who were instructed concerning the operation of the
machine and who are informed about the associat
ed dangers. The minimum age requirement must be
complied with.
To Next Page
Need help?
General
