Scheppach SM150LB User Manual

www.scheppach.com
28
|
GB
Improper handling of waste equipment may have neg-
ative consequences for the environment and human
health due to potentially hazardous substances that
are often contained in electrical and electronic equip-
ment. By properly disposing of this product, you are
also contributing to the e󰀨ective use of natural resourc-
es. You can obtain information on collection points for
waste equipment from your municipal administration,
public waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
Do not throw primary batteries or rechargeable
batteries away with household waste
As the consumer you are required by law to
bring all batteries and rechargeable batteries,
regardless whether they contain harmful sub-
stances* or not, to a collection point run by the local
authority or to a retailer, so that they can be disposed of
in an environmentally friendly manner.
*marked with:Cd = cadmium, Hg = mercury, Pb = lead
15. Disposal and recycling
The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
di󰀨erent materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices.
16. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Engine does not run.
Engine, cable or
connector defective, fuses
burnt.
Have the machine checked by a specialist. Never repair
the engine yourself. Attention! Check the fuses and
replace them if necessary.
The engine starts
slowly and does not
reach the operating
speed.
Voltage too low, coils
damaged, capacitor burnt.
Have the power supply company check the voltage.
Have the engine checked by a specialist. Have the
capacitor replaced by a specialist.
Engine producing
excessive noise.
Coils damaged, motor
defective.
Have the engine checked by a specialist.
Engine does not reach
full power.
Circuits in the network are
overloaded (lamps, other
engines, etc.)
Do not use any other devices or engines on the same
circuit.
Motor overheats easily.
Overloading of the engine,
insu󰀩cient cooling of the
engine.
Avoid overloading the engine during grinding and
remove dust from the engine to ensure optimum engine
cooling.

Scheppach SM150LB Specifications

General

Brand	Scheppach
Model	SM150LB
Category	Grinder
Language	English