SCHUBERTH SRC SYSTEM User Manual

34
8.4 USING THE SRCSYSTEM™ FOR INTERCOM WITH OTHER SRCSYSTEM™
HEADSETS
INTERCOM CHANNEL PAIRING / CONNECTION
BUTTON
PAIRING MODE LED
INDICATORS
CHANNEL “A” CHANNEL “A” BUTTON Rapid RED ashing
CHANNEL “B” CHANNEL “B” BUTTON Rapid BLUE ashing
8.4a. TWOWAY INTERCOM
Using two SRC-System™ headsets
1. While both headsets are turned OFF, turn them ON by pressing and holding
the Mobile Buttons until the Blue Lights ash three times.
2. Make sure that both headsets are now ashing slowly in Blue.
3. Choose an available CHANNEL you wish to use to pair the headset (CHANNEL
“A” or CHANNEL “B”).
NOTE: Selecting a CHANNEL that is already in use will override the paired headset on
that CHANNEL with the newly paired headset.
4. On the SRC-System™ headset, press and hold the assigned CHANNEL BUTTON
(“A” or “B”) for at least six seconds until the headset’s BLUE or RED Light be-
gins ashing rapidly, indicating it is in Intercom Pairing mode. (See Intercom
Channel Table for Pairing LED indication for each CHANNEL).
5. Repeat Step 3-4 for the second SRC-System™.
6. Within a few seconds, both headsets will show a solid light for two seconds,
indicating that the two headsets are now paired, connected and ready for use.
NOTE: If the Pairing process is not completed within two minutes the headset will
return to Standby mode.
8.4b. THREEWAY INTERCOM
The SRC-System™ oers three-way intercom conference connectivity as follows:
Rider “2” Rider “3”
Rider “1”
Use Channel “B”Use Channel “A”
In this conguration Rider “1” is paired to Rider “2” and to Rider “3”.
IMPORTANT: Since Rider “1” uses two Bluetooth® connections during the conference
mode, Rider “1” will be disconnected from the mobile phone or GPS device until the
conference mode ends. Then, Rider “1” will automatically re-connect to his mobile
phone or GPS. Riders “2” and “3” remain connected to their mobile phones or GPS
devices during the 3-way intercom call.
Pairing three SRC-System™ headsets is achieved by simply repeating the procedure in
the above section 8.4a with a third SRC-System™ headset (in a dierent CHANNEL).
1. Pair your SRC-System™ with the second SRC-System™ as described in
section 8.4a (Using CHANNEL “A”).
2. Pair your SRC-System™ with the third SRC-System™ as described in
section 8.4a (Using CHANNEL “B”)

SCHUBERTH SRC SYSTEM Specifications

General

Brand	SCHUBERTH
Model	SRC SYSTEM
Category	Headsets
Language	English