Sharp ER-A160 User Manual

29
Programming an entry digit limit for
'
,
î
,
r
and
p
keys
The limit is in effect for REG-mode operation but can be overridden in the MGR mode.
When “0” is set, the operation of the corresponding key is prohibited.
• Be very careful not to enter a wrong number for the number entry after the first
Ñ
key. Be sure
to enter the number described in the "Procedure".
• You can continue programming until
É
key is pressed for the programming described in this
section. To continue programming, repeat from the first numeric key entry.
Setting the register number
When your store has two or more registers, it is practical to set separate register numbers for their identification.
Setting the consecutive number
The consecutive number is increased by one each time a receipt is issued.
Ñ
2
≈
1000
ÑÉ
PrintKey operation example
Ñ
1
≈
123
ÑÉ
PrintKey operation example
Programming various functions
5
Entry digit limit
8
≈î É
PrintKey operation example
Entry digit limit(0-8) or
É
To program “0”
To program for another key
≈',î,rp
From left, ABCD
0001
≈
eÉ
PrintKey operation example
1Ñ
≈
Ñ É
Register number (one to three digits)
To set the register number “0”
2Ñ
≈
Ñ É
A number (one to four digits) that is one
less than the desired starting number
To begin the count from 0001

Sharp ER-A160 Specifications

General

Brand	Sharp
Model	ER-A160
Category	Cash Register
Language	English