66
5. SERVICE MENU
MS6488 Factory Menu Specication
How to Enter Factory Menu?
Press the RC buttons in this sequence: “Menu 1 1 4 7” to enter the factory menu.
Description:
5.1 INTRODUCTION
5.2 ADC ADJUST & WHITE BALANCE AUTO
ADJUST
5.3 PICTURE
5.4 SOUND
5.5 PANEL
5.6 DEBUG
5.7 GENERAL SETTING
5.8 EMC SETTING
5.9 CHANNEL TABLE
5.10 SW UPGRADE
5.11 SW INFORMATION
5.1 INTRODUCTION
SHIPPING INIT: TV Initilization and all parameter
to be default. Designed for Shipment.
BURNING MODE: TV aging mode switch.
ADC ADJUST: Change ADC parameters
PICTURE SETTING: Change Picture Setting
SOUND SETTING: Change Sound Setting
PANEL: Change panel parameters like
DEBUG: Debug mode
GENERAL SETTING: Some other settings
usualy used, and also for Debug.
EMC SETTING: Some settings may aect EMC.
CHANNEL SETTING: channel list
SW UPGRADE: Software update item.
SW INFORMATION: Display some system information.
Board Type: Display board type
Build Time: Display Firmware build time
HDCP Check: HDCP key status
HDCP22 Check: HDCP22 key status
CI PLUS Check: CI+ key status
MAC Address: MAC Address
Picture 1 Introduction
To Next Page
Loading...
Need help?
General