Sharp R-15AT Service Manual

R-15AT
9
TROUBLESHOOTING GUIDE
When troubleshooting the microwave oven, it is helpful to follow the Sequence of Operation in performing the checks.
Many of the possible causes of trouble will require that a specific test be performed. These tests are given a procedure
letter which will be found in the “Test Procedure” section.
IMPORTANT: If the oven becomes inoperative because of a blown fuse F1 (F10A) in the 2nd. interlock switch SW2 -
monitor switch SW3 - relay RY3 circuit, check the 2nd. interlock switch SW2, monitor switch SW3 and
relay RY3 before replacing the fuse F1 (F10A).
TEST PROCEDURE
CONDITION PROBLEM
POSSIBLE CASE
AND
DEFECTIVE PARTS
Home fuse or circuit
breaker blows when
power cord is plugged into
wall outlet.
Fuse F1 F10A blows when
power cord is plugged into
wall receptacle.
. does not appear
in display when power
cord is first plugged into
wall outlet.
Oven lamp does not light
when door is opened.
Oven lamp lights but fan
motor and antenna motor
do not operate.
Oven does not go into
cook cycle when START
pad is touched.
Oven seems to be
operating but little or no
heat is produced in oven
load. (Food incompletely
cooked or not cooked at
all at end of cook cycle.)
Oven goes into a cook
cycle but extremely
uneven heating is
produced in oven load
(food).
Oven does not cook prop-
erly when programmed for
Cooking Power 5 mode.
(Operates properly on
Cooking Power HI (HIGH)
mode.)
"EE9" Maximum time is
exceeded.
OFF
CONDITION
COOKING
CONDITION
ERROR MODE
MAGNETRON HIGH VOLTAGE TRANSFORMER H.V. RECTIFIER ASSEMBLY HIGH VOLTAGE CAPACITOR THERMAL CUT-OUT 2ND. INTERLOCK SWITCH PRIMARY INTERLOCK RELAY FUSE F1 F10A HIGH VOLTAGE FUSE NOISE FILTER TOUCH CONTROL PANEL KEY UNIT EXCEED MAX. HEATING TIME RELAY (RY3) RELAY (RY2) FOIL PATTERN ON P.W.B. LOW VOLTAGE WRONG OPERATION DIRTY OVEN CAVITY MISADJUSTMENT SWITCH SHORTED IN POWER CORD OVEN LAMP OR SOCKET COOLING FAN MOTOR ANTENNA MOTOR
SHORT OR OPENED WIRING
MONITOR SWITCH CONTROL SWITCH
ABC DE E E F GH I I J
K L M M N CK RE RERECKCKCKCK

Sharp R-15AT Specifications

General

Grill	No
Rotisserie	-
Control type	Buttons
Display type	LCD
Product type	Solo microwave
Certification	CE
Product color	Stainless steel
Microwave power	1000 W
Built-in display	Yes
Appliance placement	Countertop
Number of power levels	11
Current	16 A
Connected load	- W
AC input voltage	230 V
AC input frequency	50 Hz

Weight and Dimensions

Depth	424 mm
Width	520 mm
Height	309 mm
Weight	18000 g
Interior dimensions (W x D x H)	351 x 372 x 211 mm