Sharp R-23AT User Manual

7
X 2
X 2
X 2
3
2 X
Setting magnification factor
It is possible to change the magnification factor for double quantity in the memory.
Example : Suppose you want to set the magnification factor to 1.67 for double quantity in memory 1.
Choose checking mode.
ActionStep Press key Display
4
5
6
3
Choose double quantity.
Action
Step
Press key Display
within 2 sec.
NUMBER
DOUBLE
NUMBER
DOUBLE
NUMBER
1
1 6 7
NUMBER
DOUBLE
NUMBER
DOUBLE
Choose set mode.
1
2
Choose memory number.
Touch MANUAL/REPEAT key.
Enter magnification factor.
Complete memorizing.
NOTE:
When
is displayed at step 2 or step 3, the memory is not set.
CHECK
NUMBER
CHECK
POWER
%
NUMBER
1
Repeat
CHECK
POWER
%
NUMBER
2
CHECK
POWER
%
NUMBER
1
1
1
2
Choose memory number.
Cancel checking mode.
3
4
Choose memory number.
NOTE:
1. In case you want to change the magnification factor it must be set for each key separately.
2. The magnification factor can be set from 0.00 to 9.99.
3. At Step 1, any audible signals will not sound when the SET key is touched first and then an audible signal will
sound when the SET key is touched second.
MEMORY CHECK
You can check the information programmed into the memory.
Checking time and power level
Example : Suppose you want to know the information programmed into the memory 1, programmed for 4 minutes
at 60% at the 1st sequence and 2 minutes at 30 % at the 2nd sequence, and after that the memory 13,
programmed for 3 minutes at 70 %.

Sharp R-23AT Specifications