Sharp R-23AT User Manual

13
VERY IMPORTANT CAUTIONS:
• DO NOT OPERATE THE OVEN WITHOUT THE
SPLASH COVER IN PLACE.
• DO NOT REMOVE THE SPLASH COVER
UNLESS THE POWER CORD IS REMOVED
FROM THE OUTLET BECAUSE THE ROTARY
ANTENNA, WHICH IS LOCATED ON THE
CEILING, OPERATES FOR 1 MINUTES AFTER
THE DOOR IS OPENED AND INJURY COULD
OCCUR.
• DO NOT USE COMMERCIAL OVEN
CLEANERS, ABRASIVE, HARSH CLEANERS
OR SCOURING PADS ON ANY PART YOUR
MICROWAVE OVEN.
• DO NOT SPRINKLE WATER ONTO THE OVEN
DIRECTLY. IT MAY CAUSE ELECTRIC SHOCK,
LEAKAGE OF ELECTRICITY OR DAMAGE OF
THE OVEN.
Oven Exterior
The outside of your oven can be easily cleaned with mild
soap and water. Make sure that the soap is wiped off
with a moisture cloth, and dry the exterior with a soft
towel.
Control Panel
Open the door before cleaning to inactivate the control
panel keys. Care should be taken in cleaning the
control panel. Using a cloth dampened with water only,
gently wipe the panel until it becomes clean. Avoid the
use of excess water. Do not use any sort of chemical
or abrasive cleaner. To do so may cause severe
damage to the panel and make key entry impossible.
Oven Interior
1) For easy cleaning, wipe any spatters or spills with
a sort damp cloth or sponge at the end of each day
for hygienic reasons. For heavier spills, use mild
soap and wipe several times with a damp cloth
until all residues are removed.
2) Keep the ceramic floor clean at all times. If you leave
grease or fat in the cavily, it may overheat, smoke or
even catch fire when next using the oven.
CAUTION:
DO NOT REMOVE THE CERAMIC FLOOR
FROM THE OVEN.
3) Make sure that mild soap or water dose not
penetrate through the small vents in the walls which
may cause damage to the oven.
4) Do not use spray type cleaners on the oven interior.
CARE AND CLEANING
Splash cover
AT LEAST ONCE A WEEK, REMOVE THE SPLASH
COVER AND WASH BOTH SIDES OF IT IN A MILD
DETERGENT SOLUTION. BUILT-UP GREASE MAY
OVERHEAT AND BEGIN TO SMOKE. AND
OVERHEATED GREASE MAY BURN THE SPLASH
COVER. THE SPLASH COVER IS LOCATED IN
THE TOP OF THE OVEN AND MAY EASILY BE
REMOVED. REMEMBER TO UNPLUG THE POWER
CORD.
Removal:
1. Remove two thumb screws (A) as shown in Fig. 1.
2. Remove the splash cover from the oven.
Reinstall:
1. Insert two projections of the cover (B) into the holes
of the oven cavity backplate as shown in Fig. 2.
2. Secure the cover to the oven ceiling with two thumb
screws (A) as shown in Fig. 1.
Fig. 1
Door
Splash Cover
(A)
Splash Cover
Holes
Fig. 2
(B)

Sharp R-23AT Specifications