Sharp R-3A53 User Manual

R -3A53
R-3A53B
OVEN LAMP SOCKET REMOVAL
1. CARRY OUT 30 CHECKS.
2. Lift up the oven lamp socket.
3. Pull the wire leads from the oven lamp socket by
pushing the terminal hole of the oven lamp socket
with the flat type small screw driver.
4. Now, the oven lamp socket is free.
CAUTION: When replacing the oven lamp socket, re-
place it so that the side where the black
dot is put faces upward.
Own lamp sodcot
Twminal
Flat type small
Torminai holo
Figure C-7. Oven Lamp Socket
POWER SUPPLY CORD REPLACEMENT
(FOR AUSTRALIAN MODEL)
Removal
1. CARRY OUT 3D CHECKS.
2. Disconnect the brown wire of the power supply
cord from the fuse holder.
3. Remove the connector CE-230 by cutting the con-
nected wire leads to it.
4. Remove the single (1) screw holding the
green/yellow wire of the power supply cord to the
oven cavity.
5. Remove the single (1) screw holding the cord
anchorage to the oven cavity.
6. Remove the power supply cord from the oven.
Re-install
1. Insert the power supply cord into the cord
anchorages.
2. Connect the brown wire of the power supply cord
to the fuse holder.
3. Install the green/yellow wire of the power supply
cord to the oven cavity with the single (1) screw
tightly.
Blue wire of power supply cord
\
White wire of main harness
Connector CE-230
4. Make sure that the blue wire and the white wire are
stripped for 15 mm length as shown in Figure C-l 1.
5. Wind the conductors of Blue and White wires each
other.
6. Insert the stripped wire leads into the connector
CE-230.
7. Clamp the connector CE-230 with the correct tool
tightly.
Cord anchorage
Brown wire
I
/
CE230
Green/Yellow wire
-*
Figure C-8 Power Supply Cord
Replacement
for Australian Model
-7
Blue wire
29

Sharp R-3A53 Specifications

General

Brand	Sharp
Model	R-3A53
Category	Microwave Oven
Language	English