Your oven has an Energy Save Mode. This facility saves electricity when the oven is not in use.
When you have unpacked your oven and assembled the turntable correctly (please refer to pages 2 & 5)
plug the oven into your electricity supply. Open & close the door. “0” will appear on the display. The oven is
now ready for use.
The oven will default to Energy Save Mode after 3 minutes if not used. In Energy Save Mode the display is
blank and the oven cannot be operated.
To cancel Energy Save Mode:
i) Open & close the door. “0” will be displayed and the oven is ready for use.
ii) Set the clock. Please refer to “Setting the clock” on page 9. (To revert back to Energy Save Mode, follow
the procedure below).
Note: If you unplug your oven at any stage you will have to reset the clock to cancel Energy Save Mode.
To start Energy Save Mode when the clock is set.
1. Make sure the
correct time
appears on the
display.
2. Press the KITCHEN
TIMER/CLOCK SET
key 3 times.
3. Press the START/AUTO
MINUTE key. The power
will be off and the display
will show nothing.
x3 x1
Your oven has an energy save mode.
1. Plug in the oven. Nothing will appear on the
display at this time.
2. Open the door. The display will flash the message
shown.
3. Close the door. The display will show “ . 0”.
If you set the clock, “energy save” mode will be
off. If you keep “energy save” mode, go to step 5.
4. Set the clock, refer to page 9.
5. Heat the oven using the upper and lower grills
without food for 20 minutes. (For operation, see
NOTES on page 11).
8
BEFORE OPERATION
Website: http://www.sharp.co.uk/support Help Line: 08705 274277 (office hours)
ENERGY SAVE MODE
1.
2.
3.
To Next Page
Loading...
Need help?
General
