16 / 38
Siemens Climatix HMI-TM CB1P3917en_redesigned
Smart Infrastructure Functions and operations 2023-06-13
4.4 Log in
After the communication between HMI-TM and controller has been set up, users
can log in with one of the following user levels listed in the table:
Not login
The access rights of this
level are suitable for
users who view the basic
information of Climatix
range controllers.
No password required. The setting
is in accordance to the access
right from privilege 253 to 255 in
Climatix SCOPE. Refer to Climatix
for details.
End user
The access rights of this
level are suitable for
users who operate the
Climatix range controllers.
These user levels are password
protected.
Service
The access rights of this
level are suitable for
users who perform
maintenance to Climatix
range controllers.
OEM
factory
The access rights of this
level are suitable for
users who configure the
Climatix range controllers.
The specific access right for each user level can be defined by application engineer.
The password related templates in SCOPE are listed in the following table, which
can be defined by application engineer in SCOPE.
Password entering page [65410]
Password handling page [65400]
Change factory password page [65450]
Change service password page [65451]
Change end user password page [65452]
If users enter any one of these five pages from templates and press key ENTER, it
will check if the title line of the corresponding templates has defined the target
page and if the current user level has enough privileges.
If yes, it will redirect to the defined target page. If not, it will redirect to the home
page.
Press key INFO on any one of these five pages to go to the home page.
1. Press and hold key ENTER on any page (except the error report pages)
with OEM factory user level to activate the log in/off page as follows:
Password related
To Next Page
Loading...
Need help?
General
