Basic operation en
31
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.9 Soaking laundry
Note:No additional detergent is re-
quired for soaking. The appliance
uses the filled detergent for soaking
and washing.
Requirements
¡ The laundry is placed in the appli-
ance.
→"Loading laundry", Page29
¡ A programme has started.
→"Starting the programme",
Page30
1. Press Start Reload approx.
10minutes after the programme
start.
The programme pauses and the
laundry can soak.
2. Press Start Reload after the re-
quired soaking time.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press Start Reload.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page21
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press Start Reload.
13.11 Cancelling the pro-
gramme
1. Press Start Reload.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→"Programmes", Page24
3.
Remove the laundry. →Page31
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→"Buttons", Page22
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the Spin programme or a pro-
gramme for draining the water.
→"Programmes", Page24
2. Press Start Reload.
13.13 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
13.14 Switching off the appli-
ance
1. Turn the programme selector to .
2. Turn off the tap.
To Next Page
Loading...
Need help?
General
