Basic operation en
31
3. Fold the measuring aid down and
click it into place.
4. Push in the detergent drawer.
13.8 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→Page29.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page18
3. If required, add the care product.
4. Push in the detergent drawer.
13.9 Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press .
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a If you start a programme with act-
ive oxygen, the drum lights up
after the programme starts and the
mist that is created can be seen.
13.10 Adding laundry
Note:If you a start a programme with
active oxygen, you cannot add any
laundry after the programme has
started.
1. Press .
The appliance pauses.
Note:If appears, it is not pos-
sible to add laundry.
When goes out, it is possible to
add laundry.
2. Open the appliance door.
3. Add or remove laundry.
4. Close the appliance door.
5. Press .
13.11 Cancelling the pro-
gramme
1. Press .
2. Open the appliance door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse programme.
– If the water level is high, start
the Spin programme or select a
suitable programme for draining.
→"Programmes", Page24
3.
Remove the laundry →Page31.
13.12 Unloading the laundry
1. Open the appliance door.
2. Remove the laundry.
To Next Page
Loading...
Need help?
General
