21
en
Installation Instructions:
Important information
Additional information concerning gas cookers:
When installing gas hotplates, comply with the
relevant national statutory regulations (e.g. in Ger-
many: Technische Regeln Gasinstallation TRGI).
Always comply with the currently valid regula-
tions and installation instructions supplied by the
gas appliance manufacturer.
Only one side of the extractor hood may be
installed next to a high-sided unit or high wall. Gap
at least 50 mm.
Minimum distance on gas hotplates between
the upper edge of the trivet and lower edge of the
extractor hood: 460 mm.
Old appliances are not worthless rubbish. Valu-
able raw materials can be reclaimed by recycling old
appliances. Before disposing of your old appliance,
render it unusable.
You received your new appliance in a protective
shipping carton. All packaging materials are environ-
mentally friendly and recyclable. Please contribute
to a better environment by disposing of packaging
materials in an environmentally-friendly manner.
Please ask your dealer or inquire at your local au-
thority about current means of disposal.
The extractor hood can be used in exhaust air
or circulating air mode.
Always mount the extractor hood over the cen-
tre of the hob.
Minimum distance between electric hob and
bottom edge of extractor hood: 460 mm.
The extractor hood must not be installed over
a solid fuel cooker – a potential re hazard (e.g. y-
ing sparks) – unless the cooker features a closed,
non-removable cover and all national regulations
are observed.
The smaller the gap between the extractor hood
and hotplates, the greater the likelihood that drop-
lets will form on the underside of the extractor hood.
To Next Page
Loading...
Need help?
General
