Siemens RUGGEDCOM RSG2488 User Manual

Chapter 4
Technical Specifications
RUGGEDCOM RUGGEDCOM RSG2488
Installation Guide
36 Copper Ethernet Port Specifications
Parameter Value (Resistive Load)
Maximum Switching Voltage
250 VAC
30 VDC
Rated Switching Current
2 A @ 250 VAC
2 A @ 30 VDC
Maximum Switching Capacity
150 W
500 VA
Section 4.3
Copper Ethernet Port Specifications
The following details the specifications for copper Ethernet ports that can be ordered with the RSG2488.
Speed
b
Connector Duplex
b
Cable Type
c
Wiring
Standard
d
Maximum
Distance
e
Isolation
f
10/100/1000Base-TX RJ45 FDX/HDX > CAT-5 TIA/EIA
T568A/B
100 m (328 ft) 1.5 kV
10/100/1000Base-TX FastConnect
RJ45
FDX/HDX > CAT-5 TIA/EIA
T568A/B
100 m (328 ft) 1.5 kV
10/100/1000Base-TX 2-Pin A-
Coded M12
FDX/HDX > CAT-5 Local 100 m (328 ft) 1.5 kV
10/100/1000Base-TX 2-Pin X-
Coded M12
FDX/HDX > CAT-5 Local 100 m (328 ft) 1.5 kV
10/100/1000Base-TX 4-Pin A-
Coded M12
FDX/HDX > CAT-5 Local 100 m (328 ft) 1.5 kV
10/100/1000Base-TX 4-Pin X-
Coded M12
FDX/HDX > CAT-5 Local 100 m (328 ft) 1.5 kV
b
Auto-negotiating.
c
Shielded or unshielded.
d
Auto-crossover and auto-polarity.
e
Typical distance. Dependent on the number of connectors and splices.
f
RMS 1 minute.
Section 4.4
Fiber Optic Ethernet Port Specifications
The following sections detail fiber optic specifications for ports that can be equipped on the RSG2488 . The user
determines the type of optics at the time of ordering, and can determine the ports installed on a particular unit by
reading the factory data file via the ROS user interface. The specifications are organized by order code. Module
order codes are contained within each unit when it is assembled and configured at the factory. For information
about obtaining factory configuration data, refer to the ROS User Guide for the RSG2488.

Siemens RUGGEDCOM RSG2488 Specifications

General

Brand	Siemens
Model	RUGGEDCOM RSG2488
Category	Switch
Language	English