en Cleaning and servicing
50
5. Reattach the water outlet hose and
secure the connection point using
the hose clamp.
17.7 Clean the water inlet fil-
ters.
Emptying the water inlet hose
1. Turn off the tap.
2. Set the algodón/algodão pro-
gramme.
3. Start the programme and leave it
to run for approx. 70seconds.
4. Switch off the appliance.
5. Disconnect the appliance's mains
plug from the power supply.
Cleaning the filter on the tap
Note:Please read the information in
the Safety →Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
Requirement:The water inlet hose is
empty.
1. Remove the water inlet hose from
the tap.
2. Clean the filter with a small brush.
3. Connect the water inlet hose and
check for leaks.
To Next Page
Loading...
Need help?
General