35
GB
Blade assembly19
1. Remove the blade assembly19 from the blender
jug5 (see “Using and removing the blade assembly”
on page 15).
2. Pull seal18 off the blade assembly19.
3. Insert the cleaned seal or a new one.
4. Before using the device again, reinsert the blade as-
sembly19.
Deep steamer attachment3
1. Pull seal4 off the underside of the deep steamer at-
tachment3.
2. Insert the cleaned seal4 or a new one into the deep
steamer attachment3. The raised area must be visi-
ble after insertion, see figure below. Ensure that the
seal is in continuous contact with the surface without
any waves.
Lid of the blender jug24
1. Pull seal23 off the underside of the lid for the blend-
er jug24.
2. Insert the cleaned seal23 or a new one in the lid for
the blender jug24.
18.5 Cleaning, checking and
replacing the spatula
The spatula22 is provided with a detachable silicone
scraper.
For cleaning, remove the silicone scraper, and check it for
damage. Pay attention to changes (e.g. porous material or
tears).
- Both parts can be cleaned in the dishwasher.
- A new silicone scraper can be reordered (see “How to
order accessories” on page 38).
18.6 Descaling
When steaming with hard water, limescale may build up
on the parts used, especially in the blender jug5.
Normal cleaning
In most cases, the limescale deposits are removed by
cleaning in the dishwasher or by hand.
Slight limescale deposits
1. Remove slight limescale deposits, which cannot be re-
moved with normal cleaning by hand or in the dish-
washer, with a towel on which you put some
household vinegar.
2. Rinse with clear water.
Major limescale deposits
CAUTION:
~ Do not use commercially available descaling agent,
not even glacial acetic acid or vinegar essence. Use
the following gentle method.
1. Prepare a mixture of 50 % white household vinegar
and 50 % boiling water.
2. Fill this mixture into the blender jug5 or put other
furred-up parts into a container with this mixture.
3. Allow the mixture to react for 30 minutes.
NOTE: more extended reaction periods do not improve
the limescale deposits but may damage the parts perma-
nently.
4. Rinse with clear water.
5. Allow the parts to dry completely before using them
again.
__338924_1907_MC-Connect_GB_online.book Seite 35 Donnerstag, 12. Dezember 2019 10:09 10
To Next Page
Loading...
Need help?
General
