Introduction SilverCrest PMR-1200
English 11
4.5 Preparing the Charging Cradle
1. Place the charging cradle onto a stable, flat surface.
2. Plug the power adapter plug into the power receptacle (31) of the charging cradle.
3. Plug the power adapter into a wall outlet.
WARNING!
Make sure that the wall outlet is nearby and easily accessible so that you can
unplug the power adapter quickly in case of an emergency. Otherwise short-
circuit or fire can occur.
The power adapter of the charging cradle consumes power even if there is
no handheld radio transceiver placed onto it. Therefore it is recommended
that you unplug the power adapter from the wall outlet to completely
separate it from the mains and to avoid any unnecessary power
consumption.
4.6 Charging the Battery
Charge the battery packs of both handheld radio transceivers completely before using them
for the first time. Charging takes approx. 12-14 hours.
As long as the rechargeable battery pack is inserted into the handheld radio transceiver
(see page 9), you can charge it by using the charging cradle.
1. Place both PMR sets on the charging cradle
(see the following figure).
2. The charging indicator (35) located on top of
the charging cradle lights red when a
transceiver has been inserted properly and its
battery is being charged.
To Next Page
Loading...
Need help?
General
