SilverCrest PMR-1200 Getting Started
14 English
5. Getting Started
In order to be able to communicate using two PMR units, these must be set to the same
channel and to the same CTCSS/CDCSS code. Furthermore, they must be located within
range (max. 8km in open field).
The RF communications take place on a free (unscrambled) channel, i.e. other people that
have a PMR or a receiver for the set channel will be able to listen to your messages. You
can choose from 8 different channels.
WARNING! Before using the product for the first time, read the safety
instructions starting from page 2 carefully and fully, otherwise material or
personal damage may occur.
5.1 Powering the PMR On/Off
How to power your PMR on
1. Press and hold the
button (14) for at least 2 seconds. An acoustic signal can be
heard and the currently set channel will appear on the display (3).
The unit will be in receive mode as long as it is powered on and not transmitting.
How to power your PMR off
1. Press and hold the
button (14) for at least 2 seconds. An acoustic signal can be
heard and the display (3) will turn blank.
5.2 Adjusting the Volume
1. In receive mode, press the S button (11) to raise the audio
volume. The current volume level (between 1 and 16) will be
displayed.
2. In receive mode, press the T button (6) to decrease the
audio volume.
To Next Page
Loading...
Need help?
General
