16 – English
6. Before using the device for the fi rst
time
6.1. Charging the neckband speaker
Remove the neckband speaker from the packaging.
Ensure that all packaging materials have been removed.
Open the micro-USB compartment and connect the neckband
speaker to a USB power supply with an output current of at least
1000 mA using the supplied USB cable.
As soon as the neckband speaker is connected to a power source, the
built-in rechargeable battery begins charging automatically.
The battery charging time is about 3 hours.
The charging LED lights up red during charging.
The charging LED goes out as soon as the built-in battery is fully charged.
The operating LED flashes slowly if the battery charge level is
too low and the battery needs to be charged.
Remove the USB cable and close the micro-USB compartment as
soon as the battery is fully charged.
NOTICE!
Possible material damage!
Risk of damage to the device due to impro-
per use of the device.
Do not use a standard USB 2.0 or USB 3.0 port, such
as on a PC or notebook, to charge the device. Only
use an external USB power supply with an output cur-
rent of at least 1000mA.
To Next Page
Loading...
Need help?
General
