■ 60
│
GB
│
MT
SVEB 160 B2
CAUTION – PROPERTY DAMAGE
If the control lamps t/a do not switch off after a maximum
of 10 seconds during the sealing process, the appliance is
defective!
► Remove the plug from the mains power socket immediately. Do not attempt
to repair the appliance yourself. Contact the Customer Service department.
6) Open the appliance lid 1 by pressing the lid release 8 and flipping the
lid 1 upwards. Remove the bag. It is now sealed at one end.
NOTE
► Ensure that the seam is properly closed. A correct seam should be a
smooth, straight stripe without any creases.
7) Fill the bag. You must leave at least 6 cm of the bag free up to the edge to
be sealed.
CAUTION – PROPERTY DAMAGE
► Fill the bag so that no food scraps or liquids can leak out during sealing
and get into the appliance.
8) If you do not want to vacuum the air out of the bag, seal the other, open
side now.
NOTE
► Wait a few seconds to allow the appliance to cool down before sealing
the next bag.
During this cool-down phase, you cannot start the "Sealing" function.
Vacuum sealing
Vacuuming the tube film
You can also suck the air out of the bag (vacuuming) during sealing:
NOTE
► If you want to vacuum seal bags with liquid contents only, freeze the liquid
briefly so that it does not get sucked into the appliance during vacuuming.
If small quantities of liquid or food nonetheless get sucked up, they will be
deposited in the drip tray 9 that is located within the lower sealing ring 3.
IB_367892_SVEB160B2_LB5.indb 60 30.06.2021 15:44:15
To Next Page
Loading...
Need help?
General
