TWIN-NEEDLE STITCHING (Continued)
Use twin needle. Type 705 H (size 90).
INSERTING THE TWIN NEEDLE
Before inserting the twin needle, make
sure you are using the general-purpose
needle plate and that the needle position
dial is set at X ^ ^nd the stitch width
does not exceed the settings shown on
page 25.
To insert the twin needle, simply raise
needle to its highest point and loosen the
needle-clamp screw. Remove the single
needle and insert the twin needle in its
place. Tighten needle-clamp screw
securely.
threading for twin-needle stitching
For best results, use No. 50 mercerized or synthetic thread. Thread the
machine as for single-needle stitching, except pass thread between center
and back tension discs, and through right eye of needle. Attach secondary
spool pin in hole on top cover. Pass thread from second spool through guide
(by-passing the snap-in thread guide post) as illustrated, then between
center and front tension discs. Thread through remaining points, making
certain to omit the thread guide above the needle and pass thread through
left eye of needle.
26
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
maszynykrawieckie.shophurt.pl
To Next Page
Loading...
Need help?
General
