UNGERIE SEAMS
To make seams in lingerie durable and
flexible, use a combination of straight and
zig-zag stitching.
Method 1
For 1.5 cm bias seam in woven fabric:
• Straight-stitch the seam (with stitch
width at i ) on wrong side of fabric.
• Press both seam allowances in the
same direction. Then, from the right
side, top-stitch with narrow zig-zag
stitching, letting needle alternately
enter seam line and seam thickness.
Method 2
For narrow seams in nylon tricot:
• Cut fabric for 1.5 cm seam allowance.
• Straight-stitch seam line on wrong side
of fabric. Then place a line of medium
wide, open zig-zag stitching close to
the straight stitching.
SEAM FINISHES
• Needle Position: JL
• Stitch Width: \ or % (maximum)
• Stitch Length: 1,2 to 3 mm depending on
choice of stitch and fabric
• General Purpose Needle Plate and Foot
Seam edges support the garment and
should be given a durable finish if the
fabric is likely to ravel. There are two
methods of finishing seams in such
fabfics: trimming seam edge or over
edging. Make a test sample first to deter
mine which method best suits your fabric.
For a 1.5 cm Seam
Instrukcje obsługi maszyn do szycia firm Polskich jak i zagranicznych np. Singer Toyota Pfaff Gritzner Łucznik Arka
maszynykrawieckie.shophurt.pl
To Next Page
Loading...
Need help?
General
