Singer 8060 User Manual

14
EXTENSION TABLE
a. REMOVING THE EXTENSION TABLE
Hook your fi nger under the bottom left side of
the removable extension table, then slide the
table toward the left. To reattach the table, push
it to the right.
b. OPENING THE ACCESSORY CASE
Hook your fi nger to the left side of accessory
case and pull toward you.
NOTE:
Your machine’s accessories are located and
can be stored in the removable extension table.
CHANGING THE PRESSER
FOOT
The presser foot should be changed according to
the sewing technique you do.
A. Changing the presser foot
1. Turn the hand wheel toward you until the needle
is at its highest point.
2. Raise the presser foot lifter.
3. Remove the presser foot by pushing the presser
foot release lever toward you.
4. Place desired foot with its pin directly under the
slot in presser foot holder.
5. Lower the presser foot lifting lever and the
presser foot will snap into place.
CAUTION: To prevent accidents.
Turn off the power switch before you change the
presser foot.
B. Removing the presser foot holder
When attaching a presser foot or cleaning the
machine, you should remove the presser foot
holder.
1. Remove the presser foot.
2. Loosen the presser foot thumb screw and
remove the presser foot holder.
3. To replace the holder, pull up the holder as far
as it will go from bottom of presser bar.
4. Tighten the thumb screw.
NOTE: This machine is a low shank model. When
purchasing additional feet or accessories for your
machine, look for low shank feet and accessories.

Singer 8060 Specifications

General

Brand	Singer
Model	8060
Category	Sewing Machine
Language	English