24
ADJUSTING TOP THREAD TENSION
90% of your sewing will be accomplished with the word “AUTO”
exposed on the tension control dial on top of the machine.
STRAIGHT STITCHING
The correct appearance of your stitching is largely determined
by the balanced tension of both top and bobbin threads. The
tension is well balanced when these two threads ‘lock’ in the
middle of layers of the fabric you are sewing.
If, when you start to sew, you nd that the stitching is irregular,
you will need to adjust the tension control. Do this, however,
only after you have determined that the machine is correctly
threaded (see page 18 - 19).
Make all adjustments with presser foot ‘down’.
A balanced tension (identical stitches both top and bottom) is
usually only desireable for straight stitch sewing.
ZIG ZAG and DECORATIVE SEWING
For zigzag sewing and decorative stitch functions, thread
tension should be less than for straight stitch sewing.
You will always obtain a nicer stitch and less puckering when
the upper thread appears slightly on the bottom side of your
fabric.
BOBBIN TENSION
The bobbin tension has been correctly set at the factory,
so you do not need to adjust it.
CHANGING PRESSER FOOT
Be sure needle is in the up position. Raise presser foot lifter.
1. Push presser foot release button to remove the foot.
2. Place the desired foot on the needle plate aligning the
presser foot pin with the foot holder.
3. Lower the presser foot lifter so that the foot holder snaps
on the foot.
Helpful Hint: A slight adjustment to a higher number or a
lower number may improve sewing appearance.
To Next Page
Loading...
Need help?
General
