OCTAVIA
S00.5123.51.20
------------
-------------
The engine must be attached to the repair stand
MP 9-101 with engine holder MP 1-202 for car-
rying out removal and installation operations.
- Detach gearbox from engine.
!
"
- Unscrew nuts of torque converter and se-
cure to prevent it dropping out.
- Detach hoses from ATF cooler.
#
$
$
- Attach engine to repair stand MP 9-101 with
engine holder MP 1-202.
Notes:
♦ Always replace sealing rings and gaskets
when carrying out removal and installation
operations.
♦ Always replace self-locking nuts.
♦ Coat stud bolts at turbocharger with hot bolt
paste G 052 112 A3.
Installation is carried out in the reverse order;
pay attention to the following points:
- Check whether dowel sleeves for centering
engine/gearbox are present in the cylinder
block; insert if necessary.
K - Attach intermediate plate to sealing flange
and push onto the dowel sleeves -arrows-.
$
!
"
- Inspect centering of clutch driven plate, if
necessary.
- Inspect clutch release bearing for wear, re-
place if necessary.
- Apply a thin film of grease G 000 100 to the
spline of the input shaft.
ProCarManuals.com
To Next Page
Loading...
Need help?
General
