SkyTrac Systems Ltd.
Document Rev. 01.020 DOC0334 Page 21 of 49
Restricted Proprietary and Confidential Information
3.6 Installation Materials
3.6.1 PN: 102-200-01, Installation Kit for the ISAT-200R
The ISAT-200R is installed using the Installation Kit PN: 102-200-01; the kit contains the ITRAY -
200R with the Configuration Module and ARINC connectors already installed, the contacts and back
shell. Follow installation instructions as per sections 3.7 and 3.8.
3.7 Installing ITRAY-200
The ISAT-200 is to be installed in an ITRAY-200 for operation. Operation of the ISAT-200 outside
the ITRAY-200 is not supported. Note that the configuration module comes already installed on the
ITRAY-200.
1. Select a convenient location for installing the tray. The tray can be mounted in any
orientation. Allow sufficient space at the rear of the tray for cable and connector routing.
2. Attach the tray to the surface using four AN3 type bolts with lock nuts.
3. Attach the cables to the ITRAY-200 as per an approved wiring diagram.
3.8 Installing TSO Combination Antenna
3.8.1 General Notes
The Iridium
®
satellite serving a Short Burst Data call can literally be anywhere in orbit at a given
moment in time. For this reason, it is imperative that the antenna be mounted outside, as high as
possible, in a horizontal position on the aircraft, attempting to achieve a 360-degree view of the sky
with minimal obstructions.
The ISAT-200 uses the STS-ISAT-ANT combination active L1 GPS/Passive Iridium low profile,
molded radome antenna. This recommended system antenna is only available directly from SkyTrac
Systems Ltd. and is permanently installed on the outside of the aircraft. If required, please contact
SkyTrac Systems to discuss the feasibility of using an alternate antenna.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General
