SkyTrac Systems Ltd.
Document Rev. 01.020 DOC0334 Page 7 of 49
Restricted Proprietary and Confidential Information
1 GENERAL
1.1 Introduction
This manual contains information and instructions required to install the ISAT-200 Position/Data
Communicator System and more specifically, its primary component the ISAT-200 Transceiver.
1.2 Contents
This manual contains procedures and other information for installing the ISAT-200 system. It is
divided into the following sections:
Section 1 – General
This section contains a product overview and an overview of the contents of this manual. It also lists
the ISAT-200 system components, for which installation procedures are included.
Section 2 — System Specifications
This section contains tables that list the power requirements and electrical specifications for the
components of the ISAT-200 system.
Section 3 — Mechanical Installation
This section contains the procedures for the physical installation of the ISAT-200 system
components.
Section 4 — Electrical Installation
This section contains the information needed to complete the electrical connections in an ISAT-200
system.
Section 5 — Configuration of the ISAT-200
This section contains instructions on how to configure and set up the ISAT-200 system.
Section 6 — Post Installation Tests
This section contains instructions for tests to be performed after installation, to confirm that the
system has been installed correctly.
Section 7 — Airworthiness Limitations
This section describes the installation and operational limitations of the ISAT-200 system.
Section 8 — Maintenance and Continued Airworthiness
This section describes the steps required for the continued airworthiness of the ISAT-200 system.
The document reference is online, please check the correspondence between the online documentation and the printed version.
To Next Page
Loading...
Need help?
General
