SMC Networks EX600-DX Series User Manual

-13-
No.EX##-OMN0036
•DIN rail mounting
(Available for series other than SY series. Refer to the catalog for SY series.)
(1)When joining six or more units, fix the middle part of the complete EX600 unit with an intermediate
reinforcing brace (EX600-ZMB2) before mounting, using 2-M4x6 screws.
Tightening torque: 0.7 to 0.8 Nm.
(2)Mount the end plate bracket (EX600-ZMA2) to the end plate at the opposite end to the valves, using
2-M4x14 screws.
Tightening torque: 0.7 to 0.8 Nm.
(3)Hook the DIN rail mounting groove to the DIN rail.
(4)Press the manifold using its side hooked to the DIN rail as a fulcrum until the manifold is locked.
(5)Fix the manifold by tightening the DIN rail fixing screws of the EX600-ZMA2. (M4x20)
Tightening torque: 0.7 to 0.8 Nm.
The tightening torque at the valve side depends on the valve type.
Refer to the operation manual of the corresponding valve manifold.

SMC Networks EX600-DX Series Specifications

General

Brand	SMC Networks
Model	EX600-DX Series
Category	Control Unit
Language	English